Power Bond

 

Description

Powerbond Motor Vehicle Body Adhesive - 225

Technical Data

Chemical Basis: Epoxy Resin
Color: Black
Density: 1.1 g/cm3
Application temperature: +59?F to +77?F
Application time: 60 minutes*
Hardening Time: 4 hours*
Final strength: After 72 hours*
Shore D hardness (DIN 53505): 80
Tensile strength (ASTM D-638): 30 MPa*
Tensile shear strength (EN 1465): 1.7 MPa (after 4 hours)*, 13.3 MPa (after 8 hours)*, 19.0 MPa (after 17 hours)*
Resistant to: Fuels (petrol, diesel oil), motor and transmission oil, coolant
Thermal stability: -22?F to +248?F (for short peaks up to +374?F)
Shelf Life: 12 months
*measured at 73.4?F

 

High-strength two-component epoxy resin system for repairs to motor vehicle bodies.

Features
High-strength epoxy resin adhesive
- The repair restores the original strength and stiffness.
- Fewer spot welds
- Meets the requirements of motor-vehicle manufacturers
Glass-particle technology
- Even if strong pressure is exerted, an adhesive thickness of 0.7 to1.2 mm remains
Excellent stability
- The adhesive will not run on vertical surfaces (thixotropic)
Excellent corrosion protection
- The original rust resistance is maintained
- Corrosion is prevented at welds
Can be through-welded
Can be ground and painted over
Free of silicone and VOC

Applications
Structural adhesive for steel, aluminum and fiber-reinforced plas-tics (FRP, CFRP). For gluing motor vehicle body parts such as side-walls, wheel arches, roof and door plates.

Note
Not suited for load-bearing vehicle body parts (e.g. A-pillar, frame side bar). If body parts are only partially replaced, do not glue on ­visible surfaces since ­shadow seams may appear. Observe the vehicle manufacturer’s ­repair instructions.

This product can expose you to chemicals including Quartz, Carbon black , which are  known to the State of California to cause cancer.

For more information go to: https://www.p65warnings.ca.gov/